It's possible to use both the
functions within a single program, but you have to be careful because
they can interact in slightly strange ways.
sigaction function specifies more information than the
signal function, so the return value from
express the full range of
sigaction possibilities. Therefore, if
signal to save and later reestablish an action, it may
not be able to reestablish properly a handler that was established with
To avoid having problems as a result, always use
save and restore a handler if your program uses
sigaction at all.
sigaction is more general, it can properly save and
reestablish any action, regardless of whether it was established
On some systems if you establish an action with
signal and then
examine it with
sigaction, the handler address that you get may
not be the same as what you specified with
signal. It may not
even be suitable for use as an action argument with
you can rely on using it as an argument to
problem never happens on the GNU system.
So, you're better off using one or the other of the mechanisms consistently within a single program.
Portability Note: The basic
signal function is a feature
of ISO C, while
sigaction is part of the POSIX.1 standard. If
you are concerned about portability to non-POSIX systems, then you
should use the
signal function instead.
Go to the first, previous, next, last section, table of contents.